Rain sensor

A simple Arduino garden sensor

This is not the first time Arduino is proposed for gardening, you can see nice examples here and here, or here, and even here. Anyaway, I would like to tell you how I made it even though it’s not that original.

My sensor has three elements: a moisture sensor for the soil, a light sensor and rain sensor.
Let’s see the three parts separately.

Light sensor:

it’s a very standard LDR (photoresistor) example, like this one. You connect an LDR between 5V and an analog pin and the pin to a 47KΩ resistor that goes to ground.


Moisture sensor:

I have used two nails as electrodes, as suggested in many places, like here. You need two long nails and a sponge. You solder the nails to two wires. If you can’t solder the wires, just wind them around the nails and solder just the wire. The you cut the sponge to obtain a rectangle of 5cm long and you put the nails inside, this way the wires won’t go away easily.

Then you connect one of the two wires to the 5V pin, the other to an analog pin and you connect the same pin to ground through a 10KΩ resistor.

The principle is simple, the two nails are put into the soil and act as electrodes. If the soil is completely dry, there will be no current between the electrodes and the value measured at the analog pin will be zero. With a lot of water there will be a relevant current between the nails and the measured value will be higher.

I have done some experiments and my values are like this:

dry soil: 0
some little water: 200-400
some fair water: 500-700
quite a lot of water: 700-750
soaking wet: 800-…


Rain sensor:

I was inspired by these kind of sensors they sell on the Internet. To emulate it, I used a proto perf PCB board the kind with holes connected in lines. I used a thin wire, peeled a piece of it, double the length of the board and “sewed” it around the lines in order to connect lines two by two. Then with another wire you do the same but with the lines that are not connected yet. This way half of the lines (the even) belong to one wire and the other half (the odd) to the other wire. When a drop of water falls between two lines, it generates a little current that can be detected by the Arduino. To wire it to Arduino, you connect one wire to 5V, the other to an analog pin and the same pin to ground with a 10kΩ resistor.

By measuring the values at the analog pin with different amounts of water I get these:

dry: 0
some drop: 300-400
fair a mount of water: 500-600
soaking wet: 800-…


At the end, when you put all together you have something like this:

Regarding the sketch to be used on the Arduino it’s up to you. At the moment I am just measuring the values of the analog pins and doing some experiments (the code is not even worth publishing).